Wavlink Router Login

Wavlink is a Chinese networking brand competing directly in the budget WiFi 6 space, often undercutting established brands on price for comparable specs. Their admin panel is accessed at the local hostname wifi.wavlink.com or the IP address 192.168.10.1 — they use the 192.168.10.x subnet, similar to Cudy. There's no universal default admin password; Wavlink requires you to set a password during first-time setup.

Wavlink sells a mix of WiFi 5 (AC) and WiFi 6 (AX) routers, range extenders, and mesh systems — mostly targeting the value end of the market. The admin interface is simple and clean with a mobile-first layout.

Common Wavlink Models

Model	WiFi	Key Feature
WN530X4 (AX1800)	WiFi 6	Budget WiFi 6 router, gigabit WAN
WN535K3 (AX3000)	WiFi 6	Tri-band, 2.5G port option
Halo Base / Halo Plus	WiFi 5 Mesh	Whole-home mesh with backhaul
AC1200 Extender	WiFi 5	Range extender / repeater
AERIAL D4 / X1	WiFi 6E	6 GHz band support

How to Log In

1. Connect to Wavlink WiFi (default SSID is "Wavlink_XXXX" or similar) or via ethernet
2. Open a browser and go to http://wifi.wavlink.com
3. If that doesn't load, try http://192.168.10.1
4. On first visit: you'll be prompted to set an admin password — this becomes your login credential
5. On subsequent visits: enter the password you set

First-Time Setup

Wavlink routers walk through a setup wizard on first boot:

1. Select your WAN connection type (typically DHCP for cable/fiber, PPPoE for DSL)
2. Set your WiFi network name and password for 2.4 GHz and 5 GHz
3. Set an admin password — this protects the router's settings
4. The router connects and applies settings

Wavlink Halo Mesh Setup

Wavlink's Halo mesh system connects multiple nodes into a single network. Add nodes by:

1. Power on the additional node within range of the main router
2. Log in to the main router at wifi.wavlink.com
3. Go to Mesh → Node Management
4. The new node should appear — click to add it to the mesh
5. Alternatively use WPS: press WPS on both devices within 2 minutes

Troubleshooting

Problem	Fix
wifi.wavlink.com not loading	Try 192.168.10.1 directly — the hostname only works on Wavlink network
Forgot admin password	Factory reset: hold reset button 8–10 seconds — you'll need to set a new password on first login
192.168.1.1 not working	Wavlink uses 192.168.10.1 (the .10.x subnet)
WiFi 6 speed underwhelming	Check that your device supports WiFi 6 (AX) — older devices connect at WiFi 5 speeds regardless of router capability

Factory Reset

Hold the reset button on the back or bottom for 8–10 seconds with the router powered on. The LED will flash and the router reboots. After reset, you must run first-time setup again and create a new admin password.